Bitumen Flashing Primer - 1 Ltr

High quality, low viscosity solvent-borne, BITU-BOND Bituminous black paint Primer. It is weather proof and provides long lasting protection, that when dry it forms an odourless and taint-free bitumen film. Keep the water out!

Bond-It Bitumen Paint Primer can be used for the protection of ferrous and non-ferrous metals, concrete, roofing felt, fibre/cement, corrugated iron, asphalt and wood against water. Reduces corrosion and decay. It is often used on rough, porous or friable surfaces when using flashing tape to ensure a good seal.

• Drying time 6 hours (depending on temperature)
• Black colour
• Brush or Spray
• Easy to apply

Ensure all surfaces are clean, dry and dust-free. Remove any loose particles and any rust with a wire brush & soft broom. If there is any rust left it should be treated with a rust inhibitor primer. The surfaces to be treated should be completely dry.

The use of gloves is recommended.

The Bitumen paint is ready for use and does not require thinning. Apply at least two coats. It is possible to apply the paint using either a brush or spray gun. Allow each coat to dry (approximately 6 hours) before applying the next coat.

Note: At very low temperatures the coating will become less flexible, while at high temperatures it becomes soft and less resistant to degradation by the environment, and in extreme temperatures will ultimately flow.

Note: Do not use over tar based products or if surface temperatures can rise above 65°C (149°F).

• 1 Litre covers 4-6 metres squared (depending on porosity)
• Drying time 6 hours (depending on temperature)
• Can be applied using a brush or spray
• Easy to apply
• Black colour, so it will match bitumen